Mold Solutions

Mold Solutions for Your Home

Mold usually occurs in areas with high humidity, such as basements, bathrooms, laundry rooms, and kitchens. Mold spores can cause allergies, breathing problems, and even more severe health problems. Prevention is the best of all possible mold solutions, and here are some ways you can protect your home and your family.

First of all, you must control the moisture in the home. Dehumidifiers, either whole house or room sized, can help keep the humidity level down. If the humidity is below fifty percent, mold will be deprived of its most important nutrient.

One of the best mold solutions is to take spores out of the environment. Every time you open the door, new spores will be allowed in. Removing them with an air filter and using a HEPA vacuum cleaner can help. Both products will trap spores and keep them from circulating throughout your home. You will not, however, be able to eliminate them altogether.

Wool products are naturally resistant to mold. Wool carpets, mattress covers, and comforters can help reduce the possibility that spores can take root in your home. Natural cotton, alpaca, and latex are also good materials for mold solutions.

Steam cleaners can also be helpful, especially if anyone in the home has chemical allergies. These machines will clean and disinfect without the use of cleansers. They are also effective at killing mold and mildew.

Mold can grow on virtually any surface. All that is needed is the spore, water, and a source of food for the mold. Carpet, dust, and most materials used in home construction can all provide nourishment for mold. Spores cannot be eliminated except with clean room technology, which means the only one of the mold solutions under your control is the moisture level. You can also attempt to eliminate a source of food for the spores.

Any leaks need to be repaired as quickly as possible. Wet areas should be dried thoroughly. If there are any signs of mold growth, the best remedies involve the replacement of the material that is contaminated.

Homes and buildings that have been involved in flooding, however minor it might have seemed, are prime candidates to need mold solutions. Even a small amount of water can lead to mold growing behind sheetrock, trim, and wallpaper. Water on a carpet will soak through to the padding and sub-flooring, and mold will thrive. Such hidden areas of mold are sometimes very difficult to locate and usually require the replacement of the materials.

One of the best do it yourself mold solutions is to prepare a boric acid spray. To make a half gallon, mix 1 quart of water, 1 pint of white vinegar, 1 pint of hydrogen peroxide (preferably 35%) and one-half cup of boric acid. Spray it on the mold to kill it. Wait fifteen or twenty minutes, then use a wire brush to scrub the area clean. Apply a second coat to help prevent regrowth. Always wear rubber gloves, eye protection, and a face mask when cleaning mold to prevent inhaling the spores.

 

 

 

 

 

Many, if not all of the links on this website are affiliate links which means that we will be compensated if you choose to buy at some point in the near future. Please accept our sincere thanks for your support.

Technorati Tags: Preventing Mold, Mold Cleanup, Mold Solutions

Articles

• Mold Removal
• Bathroom Mold
• Mold Resistant
• Mold Solutions
• Prevent Mold



• Social Bookmark This Page
• 
• 
• 
• 
• 
• 
• Privacy Policy
• Terms of Use
• Contact Us
• About Us
• Sitemap